Three different looks in one tool! Each styling attachment (curling iron, wand, and waver) snap easily into the handle to create a variety of styles. Features easy button release to change styling attachments. Attachments have a ceramic coating for less frizz and tons of shine. Ergonomic handle provides a better grip for comfortable styling. Stand integrated into handle. Ionic Technology leaves hair feeling silky with less frizz. Infrared Technology helps provide uniform heat. Heats hair from inside-out to help maintain the integrity of the outer cuticle layer for healthier-looking hair. Waver has creaseless edge for smooth waves. Includes a Drybar signature heat proof storage and travel case.
Attachments included:
Turn off and allow to cool before switching styling attachments. Guaranteed with a 2-year limited warranty.
1-inch (2.5 cm) Wand: Section hair into clean, 2-inch (5 cm) sections. Begin styling at the front. Point the tip of the tool downward and starting at the root, wrap the hair around the barrel, leaving about an inch (2.5 cm) at the end of the hair section free to hold on to with your fingers. Hold in place for several seconds, until desired wave or curl is achieved (time will vary with thickness of hair). Release hair and pull tool upward. Repeat with all sections.
1.25-inch (3.2 cm) Curling Iron: Section hair into clean, 2-inch (5 cm) sections. Begin styling at the front. Clamp hair 2 inches (5 cm) from the end of the section with the clamp facing downward. Pull through to the end of the section to create tension and roll upward, holding the iron horizontally and wrapping the hair evenly around the barrel. Hold for a few seconds, then holding the iron vertically gently open and close the clamp and pull downward to release the section.
0.75-inch (2 cm) Waver: Section hair into clean, 3-inch (7.5 cm) sections. Hold the tool horizontally, press to open the clamp and capture the top of the hair section between the barrels and clamp. Release clamp and hold in place for several seconds until desired definition is achieved. Open the clamp and move down the section. Repeat until the whole section is waved. For a deeper, more defined wave, keep the section clamped a few seconds longer.
Ensure tool is turned off and wait until completely cool before changing attachment.
To remove attachment: Press and hold both release buttons located on the top of the handle on each side. Gently pull upward on the attachment barrel to release.
To add attachment: Align the notches inside the handle with the notches on the attachment. Slide into the handle until it snaps into place. You should hear two clicks.
Sign In 
